2005 Custom Stardust 32 Express

Cold Molded Boats

Cold molding is a building technique that laminates multiple layers of wood veneers, or sometimes plywood, in various directions over a jig, creating a light, strong hull. An exterior layer of fiberglass is added for abrasion resistance. The layers are bonded with epoxy, and sometimes, carbon fiber or Kevlar is incorporated for strength and weight savings. The process is called cold molding because the epoxy cures at room temperature, rather than requiring heat.

• Teak covering boards
• Minimal draft of 2’11” due to prop tunnel
• Propped conservatively for efficiency
  • 2,200 RPM = 21.5 knots
  • 2,300 RPM = 23 knots
  • 2,700 RPM = 28 knots
• Large cockpit
• Cockpit cover that converts into cockpit shade
• Freshwater washdown
• Saltwater washdown
• Rocket launcher in cockpit
• Cockpit overhead lighting
• Tuna door
• Hard top with full tower
• Outriggers
• Center rigger
• Teaser reel
• Electric reel outlets
• Tackle storage
• In deck fish boxes
• Forward bench seating
• Over/under bunks
• Refrigerator with remote compressor in Engine Room - new compressor 2023
• Vizio TV
• Wet Sound speaker system - 10" subwoofer and 8" at the helm; 6" under the covering boards
• Bow thruster – Side Power SE80
• Jabsco electric head with holding tank
• Dometic 7k HVAC system – will run off the inverter
• Danforth anchor with 25’ of ¼” chain and rode
• Recent bottom paint (August 2024)

• Simrad Multi-Function Displays
• AIS receive
• Garmin autopilot with remote
• Standard Horizon VHF radio
• Fusion marine stereo

• Cummins 6CTA 8.3L 450hp with 1,652 hours
• Upgraded 55A alternator
• ZF marine transmission
• Racor filtration
• (2) Saddle fuel tanks gravity feed to center tank
• All fuel tanks have access ports and have been recently cleaned
• Fireboy automatic fire suppression
• Dripless shaft seal
• 1.75-inch stainless-steel shaft
• 4-blade Nibral 28” propeller
• Hydraulic steering
• Lenco electric trim tabs
• Xantrex 40A charger/inverter
• Sterling battery chargers - 1x dedicated to thruster and 1x to house banks
• Victron bluetooth shunt to monitor house bank voltage
• 30A shorepower
• Rule Mate 2000 GPH bilge pumps – 5x (1x cabin, 2x ER, 2x aft bilge)
• High water alarm
• 2x Group 31 starting banks – 2020
• 4x Group 31 house banks - 2023

Engine hours are as of the date of the original listing and are a representation of what the listing broker is told by the owner and/or actual reading of the engine hour meters. The broker cannot guarantee the true hours. It is the responsibility of the purchaser and/or his agent to verify engine hours, warranties implied or otherwise and major overhauls as well as all other representations noted on the listing brochure.